Features
NORM: The output wattage is the same as your initial wattage setting; HARD: in the first 1.5 seconds, the output wattage is 15% higher, afterwards it will revert to the initial wattage; SOFT: in the first 1.5 seconds, the output wattage is 15% lower, afterwards it will revert to the intial wattage.
Optima Pod ModBy accurately calculating the airflow volume through the airway into the coil, the airflow is guaranteed to meet the demands of atomizing the eliquid.
Optima Pod ModRebuildable Mesh Coil.
Optima Pod ModThe cotton is compressed to different degrees of tightness using the ∮4.8 and ∮5.0 sides. The ∮4.8 side of rod makes the cotton more loose and the taste more wet; while the ∮5.0 side makes the cotton more tight and the taste less wet.
Optima Pod Mod50W
Optima Pod ModThe airflow volume is controlled by the coil aperture, on the basis of which the optimum taste is created, so that you can vape it directly without worrying about how to adjust the airflow.
Optima Pod ModThe stainless steel wires are used for wicking, above the base level allows them to have a larger contact area with the cotton, which makes it more effective in wicking and avoids dryhit issue.
Optima Pod ModPlease check if the coil is installed correctly as the below photo. There's no gap when the coil is installed correctly.
Optima Pod ModPlease check if the positive pole of the coil and the silicone rubber insulator are installed correctly.
Optima Pod ModA Manners pod cartridge can last 5-8 times of E-juice refill
Manners PodThe side fire button is to avoid accidental touch.
Manners PodThe mouthpiece of Manners Pod is inclined providing a elegant and ergonomic vaping experience.
Manners PodAbout 40 minutes.
Manners PodYes, quite suitable.
Manners PodManners Pod device*1 1.4 ohm 2ml pod*1
1.0 ohm 2ml mesh coil*1 User manual*1
Type-C cable*1 Warranty card*1
Note: Leather case is sold separately
Pull out the cartridge before opening the rubber stoper!
Jester PodIt may be that the coil is not inserted correctly. When inserting the coil, the two ends of the coil should be aligned with the top and bottom of the cartridge.
Jester PodThe 0.5Ω coil can support 3.3V& 3.8V, does not support 4.8V, only when the coil resistance is above 0.5Ω can support all three voltages.
Jester PodRecommended wire specification: 28ga 30ga Recommended wire diameter: Ø2.0 Maximum diameter: Ø2.5 (when diameter is 2.5, the thickest wire can only be 26ga)
Jester PodWhen using a 0.5 ohm mesh coil, only constant voltage mode can be used. It can only use the constant voltage 3.3v (purple light) or 3.7v (blue light) if the coil resistance is 0.5ohm.
Galaxies MTL Starter KitRecommended 0.8-1.2 ohm coil; Recommended power range: 14w-22w.
Brunhilde MTL RTAPay attention to distinguish the airhole and the filling port. The filling hole have a water drip sign.
Brunhilde MTL RTARecommended 0.2-0.6 ohm coil; Recommended power range: 60w-120w.
Brunhilde RTAPay attention to distinguish the airhole and the filling port. The filling hole have a water drip sign.
Brunhilde Top Coiler RTA