What should I do if the cartridge is easily damaged while filling?
Pull out the cartridge before opening the rubber stoper!
Jester PodPull out the cartridge before opening the rubber stoper!
Jester PodIt may be that the coil is not inserted correctly. When inserting the coil, the two ends of the coil should be aligned with the top and bottom of the cartridge.
Jester PodThe 0.5Ω coil can support 3.3V& 3.8V, does not support 4.8V, only when the coil resistance is above 0.5Ω can support all three voltages.
Jester PodRecommended wire specification: 28ga 30ga Recommended wire diameter: Ø2.0 Maximum diameter: Ø2.5 (when diameter is 2.5, the thickest wire can only be 26ga)
Jester PodWhen using a 0.5 ohm mesh coil, only constant voltage mode can be used. It can only use the constant voltage 3.3v (purple light) or 3.7v (blue light) if the coil resistance is 0.5ohm.
Galaxies MTL Starter KitRecommended 0.8-1.2 ohm coil; Recommended power range: 14w-22w.
Brunhilde MTL RTAPay attention to distinguish the airhole and the filling port. The filling hole have a water drip sign.
Brunhilde MTL RTARecommended 0.2-0.6 ohm coil; Recommended power range: 60w-120w.
Brunhilde RTAPay attention to distinguish the airhole and the filling port. The filling hole have a water drip sign.
Brunhilde Top Coiler RTA